My Ham Shack Personal Web Pages


First Rig/Station ?

From KA6KBC

4/29/2008 3:54:21 PM (1 comments) Add a commentAdd Comment

Hey All,



So what was your first Rig/Station ?



This is back in 1979 or so, when I first got my Novice Ticket. For me my first Rig was a Homebrew 6L6 Transmitter that my Dad (WB6CGN SK) and I built. I remember that I had to order Crystals from a company in Florida (CW Crystals ?) and it took about 6 Weeks to get them. So I had a transmitter that I could not test for weeks after building. I ended up with two crystals that worked - one at 7.125MHZ and one at 7.118MHZ. I put out a blistering 10 watts. My dad was a really “Old School” Ham – Even back then not many people Homebrewed, but he thought it was the best way to learned. It was a great way to start out in the hobby.



For my receiver my Dad loaned me his old Collins 75A Receiver. It was as big as a barn. I still have the thing in the garage



For my Antenna I had a Dipole over the top of the house and into the Trees. At the time I did not realize that most of my power was going in the trees :)



As a Novice none of us really knew what we were doing, but it was lots of fun. It took me weeks to make my first CW contact. Back then you got really good at sending "CQ CQ CQ DE KA6KBC" over and over again. I did start making a few contacts then started getting QSL cards, which was a rush. I upgraded from Novice to General to Advanced, but still only had a CW Rig :(



I later upgraded to an Old Collins Transmitter (1950's) with a VFO, which at the time was a major upgrade, but still used the Collins 75A Receiver.



I later upgraded again to an old HeathKit SB101 (?) Transceiver. Wow - major upgrade as I could operate more than 40 Meters CW. Now I had SSB and more bands.



My final upgrade was a Kenwood TS520S, which I got back in 1982 and is still my only HF Rig, but might upgrade again in a few years :)



Those were the days – Fun stuff.



- Bill - KA6KBC

Comments

by Dick, N2UGB. 5/4/2008 3:56:37 AM

I was licensed back in 1980. I've foolishly and unnecessarily gone through a lot of rigs since then, but I think that one of my first was a TenTec Triton 540. Great cw rig. Simplicity itself. Never did care for the mostly non-metalic cabinet, though.

That was followed by a TS-520SE.

I'm stricly QRP now with OHR equipment, an FT-817, and an SG-2020.

I have a TS-520S, fully filtered that I put to a dummy load from time to time to keep the controls "supple".

But the QRP rigs are the one's in use. And the one's likely to be with me until they become unrepairable.

73
Dick


   Login to Add a Comment

    - or -

Add A Comment Here If You're Not Registered with MyHamShack.com

Name
Email
Callsign
Comment
Verification Code Verification Image
Verification Code Entry
(case sensitive)